Panasonic VL-G201 - Manual (Page 32)

32
Using the Unit
{
PUSH} mode (Push to talk mode)
1
When a ringer tone is heard, press {TALK}.
2
Speak to the visitor.
3
To end the conversation, press {TALK}.
L
The display will turn off.
{
AUTO} mode (Auto talk mode)
This mode allows you to answer the call by voice. Speak a brief reply into (or toward) the
monitor station, such as “Yes?” or “Hello?”. This reply is used to start {AUTO} mode; the
visitor will not hear your reply. The monitor station will beep to indicate {AUTO} mode has
started and you may then speak to the visitor.
1
When a ringer tone is heard, answer “Yes?” within 30 seconds.
L
A beep will sound to indicate that you can talk to the visitor (hands-free conversation).
2
Speak to the visitor.
3
To end the conversation, press {TALK}.
Note:
L
Make sure you are within about 50 cm of the monitor station.
L
You can also answer the call by pressing {TALK}.
L
Your initial reply should be brief (less than 1 second), otherwise {AUTO} mode will not start.
L
If a visitor calls you, a loud, brief sound (such as a barking dog) may start {AUTO} mode
even though you have not replied by voice.
{
HOLD} mode (Hold to talk mode)
1
When a ringer tone is heard, press and hold {TALK} to speak to the caller.
L
A beep will sound and the Talking indicator will light.
2
To listen to the visitor, release {TALK}.
L The Talking indicator will turn off.
3
To speak again, press and hold {TALK}.
4
To end the conversation, tap {TALK}.
Note:
L
Make sure you speak to the caller only while pressing {TALK} and release {TALK} when
you have stopped speaking so that the caller can speak to you.
G201CE(E).book Page 32 Friday, November 11, 2005 4:46 PM