Premier Mounts CPD10WALLARM - Manual (Page 4)

CPD10WALLARM
Page 4 Visit Premier Mounts website at http://www.mounts.com Installation Instructions
  Measure distance from center of lens to the top of
the bracket (C).
  Add the distance from the ground to the top of
the screen (A). Add the projector manufacturers
recommended offset from the projector manual
(B). Add the measurement from Step 1 (C), and
then add 2.5” to the total.
(Example: A + B + C + 2.5” = ?)
  Add the measurements to determine the mounting
height mark. Place a mark at the top of the total
calculated height measurement starting from the
ground up. This mark will represent the lower
edge of the wall plate.
In order to determine the installation height and
throw distance, the projector bracket must be
mounted to the projector. Please refer to the
Installation Instructions prior to performing the
following steps.
Refer to the projectors User’s Manual to
determine the offset of the projector lens to the top
of the screen/whiteboard (B).
Legend
A - Distance from ground to the top of the
screen/whiteboard (viewable area).
B - Manufacturers recommended offset
measurement. This measurement will
be listed in the Users Manual.
C - Center of the lens to the top of the
projector
bracket.
Add 2.5” to the calculated total.
This total distance will be the location for
the bottom rail on the wall plate.
Lens
Projector
Bracket
Projector
Determining the Installation Height
Top of
Screen
Mark
Ground