beautypg.com

General information safety information – Philips FW-D5D User Manual

Page 8

background image

3139 116 19774

8

English

General Information

• The typeplate (which contains

the serial number) is located at
the rear of the system.

• Recording is permissible if

copyright or other rights of third
parties are not infringed.

• This device complies with the

Federal Communications
Commission (FCC) rules, part 15
and with 21 CFR 1040.10.
Operation is subject to the
following two conditions:
– This device may not cause

harmful interference, and

– This device must accept any

interference received, including
interference that may cause
undesired operation.

Environmental
Information

All unnecessary packaging has been
omitted. We have tried to make the
packaging easy to separate into three
materials: cardboard (box), polystyrene
foam (buffer) and polyethylene (bags,
protective foam sheet).

Your system consists of materials which
can be recycled and reused if
disassembled by a specialized company.
Please observe the local regulations
regarding the disposal of packaging
materials, exhausted batteries and old
equipment.

Energy Star

As an ENERGY STAR

R

Partner, Philips

has determined that this product meets
the ENERGY STAR

R

guidelines for

energy efficiency.

Accessories

(Supplied)

– Remote control
– Batteries (two AA size) for remote

control

– AM loop antenna
– FM wire antenna
– AC power cord
– CS-05 speaker package (includes one

pair of surround speakers and one
center speaker)

– CVBS cable cinch

GENERAL INFORMATION

SAFETY INFORMATION

Safety Information

• Before operating the system, check

that the operating voltage indicated
on the typeplate (or the voltage
indication beside the voltage
selector) of your system is identical
with the voltage of your local power
supply. If not, please consult your
dealer. The typeplate is located at the
rear of your system.

• When the system is switched on, do

not move it around.

• Place the system on a solid base (e.g.

a cabinet).

• Place the system in a location with

adequate ventilation to prevent
internal heat build-up in your system.
Allow at least 10 cm (4 inches)
clearance from the rear and the top
of the unit and 5 cm (2 inches) from
each side.

• Do not place the system on soft

carpet that will cover the ventilation
hole at the bottom.

• The system incorporates a built-in

safety feature that prevents
overheating.

• Do not expose the system to

excessive moisture, rain, sand or heat
sources.

• Under no circumstances should you

repair the system yourself, as this will
invalidate the warranty!

• If the system is brought directly from

a cold to a warm location, or is
placed in a very damp room,
moisture may condense on the lens
of the CD/DVD unit inside the
system. Should this occur, the player
will not operate normally. Leave the
power on for about one hour with
no disc in the system until normal
playback is possible.

• Electrostatic discharge may cause

unexpected problems. See whether
these problems disappear if you
unplug the AC power cord and plug
it in again after a few seconds.

• To disconnect the system from

the power supply completely,
remove the AC power plug
from the wall socket.

pg 01-43/D5/37-Eng

7/13/00, 11:50 AM

8

This manual is related to the following products: