Pioneer PRO-610HD - Manual (Page 75)

PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5
267
8 RETURN button
Press to set the Projection Monitor to its initial mode.
Initial mode
Input selector: Set to TV.
TV channel: Remains at the last channel set.
VOLUME: Remains at the last setting.
MUTING: OFF
PICTURE
MODE: STD
Parameters: Set to 0.
3D Y/C LEVEL: 3
3D NR LEVEL: 3
COLOR TEMP: STD
FLESH TONE: ON
PURECINEMA: HQ
SVM HIGH
SOUND
MTS: MAIN
Parameters: Set to 0.
SURROUND: OFF
SUPER BASS: OFF
SCREEN
MODE: NATURAL WIDE
V. POSITION: Set to 0.
CC: OFF
DPO: OFF
SYSTEM IN/OUT
SPEAKER: NORMAL
AUDIO OUT: FIXED
SYSTEM MODE: OFF
DTV OUT: OFF (When the SH-D09 is connected)
•
When this button is pressed while adjusting the MULTI-
POINT convergence, the MULTI-POINT convergence
returns to the initial mode.
9 VOLUME buttons
Press plus (+) button to increase the volume, press minus (–)
button to decrease it.
0 INPUT 4 jacks
These inputs are for Video Movie and VCR. Use RCA-type pin
plug cords (the same as those used in Hi-Fi systems) and S-
VIDEO cords for connections. When the audio source to be
connected is monaural, connect the source to the L-(MONO)
jack.
CAUTION:
Do not press any operation button on the Projection Monitor
or the remote control unit while recording. Signals from the
MONITOR OUTPUT jacks may be temporarily interrupted
when a button is pressed.
ATTENTION
The Projection Monitor Receiver will not function properly in
the following cases.
•
An electrical discharge in the CRT.
•
Lightning storms.
•
High static electricity environment.
•
Poor voltage regulation in the power source.
If the Projection Monitor does not operate properly, reset it as
follows:
1. Turn off the power of the unit with the 4 MAIN POWER
switch.
2. After approximately 1 minute, turn on the power with 4
MAIN POWER switch and 5 POWER button.
If the normal operation cannot be restored after the above
treatment, immediately unplug the power cord and call your
nearest PIONEER-authorized service center.
NOTE:
On rare occasions, an electrical discharge may occur inside the
CRT. It makes a short, sharp pop and either no sound is produced
or the volume level changes by itself. The SPLIT screen and
SEARCH screen functions will be cancelled automatically if an
electrical discharge occurs when this function is engaged.