Pioneer PRO-610HD - Manual (Page 5)

197
PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5
If POWER SUPPLY ASSY
Brightness Adjustment ( ∗ 2)
Focus Adjustment (VR1: FOCUS VR) (
∗
2)
Screen Size Adjustment (
∗
2)
Convergence Adjustment ( ∗ 2)
White Balance Adjustment (
∗
2)
1
3
5
6
7
No adjustment is required is repaired or replaced
If AV I/O ASSY No adjustment is required is repaired or replaced
If OTHER ASSY No adjustment is required is repaired or replaced
If DEFLECTION SERVICE ASSY is repaired or replaced
Brightness Adjustment (
∗
1)
White Balance Adjustment (Composite STD : ∗ 1, Others : ∗ 2)
1
7
If R, G or B CRT DRIVE ASSY is repaired or replaced
White Balance Adjustment ( ∗ 2) 7 If SIGNAL ASSY is repaired or replaced
Focus Adjustment (
∗
2)
Test-cross Position Check ( ∗ 2)
Screen Size Adjustment (
∗
2)
Convergence Adjustment ( ∗ 2)
3
4
5
6
If DIGITAL CONV. ASSY is repaired or replaced
Brightness Adjustment (
∗
1)
Deflection Yoke Adjustment (
∗
1)
Focus Adjustment (Lens : ∗ 2, VR1 Focus VR : ∗ 1)
Convergence Adjustment (
∗
2)
White Balance Adjustment (Composite STD : ∗ 1, Others : ∗ 2)
1
2
3
6
7
If CRT ASSY (R, G or B) is repaired or replaced
Brightness Adjustment ( ∗ 2)
White Balance Adjustment (Composite STD :
∗
1, Others :
∗
2)
Panel Adjustment (
∗
1)
Panel Adjustment for DTV ( ∗ 1)
1
7
8
9
If VIDEO ASSY is repaired or replaced
Screen Size Adjustment ( ∗ 2)
Convergence Adjustment (
∗
2)
5
6
If CONV. AMP ASSY is repaired or replaced
Test-cross Position Check (
∗
2)
White Balance Adjustment (
∗
2)
4
7
If SUB VIDEO ASSY is repaired or replaced
Focus Adjustment (Lens :
∗
1, VR1 Focus VR :
∗
2)
Convergence Adjustment (
∗
2)
3
6 If LENS ASSY (R, G or B) is repaired or replaced
Convergence Adjustment (
∗
2) 6 If MIRROR and SCREEN is repaired or replaced
Note :
*1: Readjustment necessary
*2: Turn on the power and confirm the screen. When adjustment deviates, it is readjusted if necessory.
• When the EEPROMs are replaced, check the status of the unit.
• If any IC of the EEPROM is damaged, readjustment of all the items is necessary.
• The necessary adjustment items differ, depending on the assembly or optical part replaced. Check and readjust the adjustment items
corresponding to the replaced assembly or part, following adjustment procedures 1 to 9.
Example: When the DIGITAL CONV. Assy is replaced, perform the following:
3. Focus check/adjustment
→ 4. Test-cross position check/adjustment → 5. Screen size check/adjustment
→ 6. Convergence check/adjustment
Assembly Adjustment Location Guide