Pioneer PRO-610HD User Manual
Page 72
PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5
264
SPECIAL NOTES
MOVIE or GAME mode may not be selected when receiving RGB
input.
GAME mode setting:
•
All signals output from the Projection Monitor will be unaffected.
Only the original output signal is sent through the output jacks.
Picture Adjustments
• The COLOR, TINT, and SHARP settings may not be changed
when receiving RGB input.
• When DPO is on, CONTRAST, BLACK LEVEL and COLOR cannot
be adjusted.
• When picture quality has been adjusted, the user mode data
will be overwritten with the new settings.
Picture Quality setting:
Only the COLOR TEMP settings may be changed when receiving
RGB input.
Other Picture Quality setting:
PURECINEMA adjustment:
Normally, this function should be set to “HQ” (High Quality),
however, occasionally this setting may cause slight syncopation
problems with the audio track. If you are bothered by this, select
“STD” (Standard) or “OFF”. If “OFF” is selected, normal
progressive signal processing is performed.
Sound Adjustments
BASS, TREBLE and BALANCE are SPEAKER mode settings, which
can only be adjusted when mode is NORMAL.
• This function cannot be used when the SPEAKER mode is
CENTER IN or when the SPEAKER mode is OFF and AUDIO OUT
mode is FIXED.
• The surround effect cannot be obtained with mono sound.
• In some cases, the surround effect may be minimal.
Surround Mode setting:
Speaker and AUDIO OUT Setting:
• After the speaker mode is set to CENTER IN, the volume of the
center speaker should be controlled from this monitor.
• If AUDIO OUT is set to VAR and the sound is distorted, lower
the Monitor volume.
Connection with Receiver (1)
Connection with Receiver (2)
SYSTEM MODE ON :
•
The input cannot be switched even if you press the Input selector
button of the remote control unit.
•
On the sub-picture of a SPLIT screen, only the input signal from
the antenna can be displayed.
•
The SEARCH screen function will not be operable.
•
No signal will be output from the AUDIO OUTPUT terminal.
•
Setting SYSTEM MODE ON will cause RGB input signals to not
be displayed.
•
When 1080i or 480p component signals or RGB signals are input,
SCREEN MODE will be limited to FULL.
Changing Screen Mode