Polaroid Polaview 305 - Manual (Page 110)

Unknown/Unrecognized video source
Occasionally, you may encounter an unknown or unrecog-
nizable video signal while using the projector. If this should
happen, use the following steps to connect and adjust the
projector:
1 Connect the projector to the video source and make sure
that the power is on.
2 Select User A or User B for a custom setting (Advanced
menu).
3 If it is not already selected, select Computer input from the
Source menu.
4 Check the Input Measurements window and record the V
Sync, H Sync, and Lines values for the incoming video sig-
nal. Consult your computer documentation for the Video
Data Rate (dot clock) specifications.
Input measurement
window
Note: The Lines value is larger than the vertical lines of
data displayed. This is due to additional vertical lines that
are sent by the video system for video processing timing
purposes.
5 In the Source mode menu, select the source mode closest to
the values recorded in the preceding step.
6 Make adjustments as necessary to fine-tune your display.
7 Close the menus to save these settings.
Troubleshooting 107
Input Measurements
V Sync: 72.00 Hz
H Sync: 78.00 KHz
Lines: 1057 Sense: HLHL