Panasonic WJ-HD500B - Manual (Page 89)

89
■ Alarm Recording
The Disk Recorder activates the recording alarm status within the specified recording mode, when an externally connected
alarm sensor is turned on, or when the installed Video Motion Detector (optional) is activated.
The alarm recording mode is determined by the setup in the WJ-HD500 SETUP menu. Described below is an alarm recording
mode for each recording mentioned above.
Note: The received alarm is ignored when the Disk Recorder is recording images in the Emergency Recording. (the alarm
log is stored in the ERROR REPORT table.)
● Alarm Recording for Manual and Power-on Recording
The Disk Recorder records an alarm status based on the setup made in the MANUAL REC SETUP menu of the WJ-HD500
SETUP menu.
It records the images as shown below in Time Lapse Recording mode with the specified recording rate, quality and duration.
The recording pattern varies according to the setting for the Dynamic Recording (DYNAMIC REC) parameter.
• Set to OFF
Records all input images in sequence starting from video input which have activated alarm.
C1 C3 C2 C3 C4 C2 C4 C5 C6 C3 C4 C5 C6
T T T
Start
Thumbnail Thumbnail Thumbnail
Alarm 2 in Alarm 3 in
• Set to ALM-PRI
Records the alarm-activated input images preferentially over other video inputs.
• Set to ALM-ONLY
Records the particular images which have activated the alarm.
Notes:
• When the TIMER parameter is set to EXT in the
setup menu for Power-on Recording, the Internal
Timer Recording is disabled.
• Make sure to keep the POWER switch on the rear of
the Disk Recorder set to ON.
C1 C4 C2 C3 C4 C1 C4 C2 C4 C15 C1 C4 C2
T T T
Start
Thumbnail Thumbnail Thumbnail
Alarm 4 in Alarm 15 in
C1 C4 C2 C3 C4 C4 C4 C4 C4 C15 C15 C15 C15
T T T
Start
Thumbnail Thumbnail Thumbnail
Alarm 4 in Alarm 15 in