Panasonic WJ-HD500B - Manual (Page 35)

35
■ Status Display
The status display shows the system status of the Disk
Recorder.
It is displayed on the screen of the Multiscreen Monitor dur-
ing recording and playback and contains the following
information.
The status display is only available on the screen of the
Multiscreen Monitor.
Pressing the DISPLAY button toggles all displays on the
monitor on and off.
(The Spot Monitor only displays the Group Title and
Camera Title.)
q Time Display
Displays the hours (24-hour), minutes, and seconds.
“
✽” indicates that summer time mode is selected.
w Date Display
e Recording Status and Recording Number Display
Displays the recording status and recording number
currently being played back.
The recording number is automatically assigned when
recording.
REC ✽✽%: Indicates that images are being recorded.
(
✽✽ indicates the remaining space of the Hard Disk
when the HDD DISKEND is set to STOP in the setup
menu.)
EMERGENCY: Indicates that an Emergency Recording
is being made.
✽✽✽✽✽✽✽✽✽: Recording Number (during playback)
MONITORS AND DISPLAYS
■ Spot and Multiscreen Monitor
The WJ-HD500B Disk Recorder can be connected to two
Monitors.
The monitor displays the video signal according to the con-
nection made, as shown below.
Spot Monitor: The monitor that is connected to the
SPOT OUT connector on the rear of the Recorder.
It only displays the video input in single spot or sin-
gle sequence.
Displaying the Disk Recorder’s playback is dis-
abled.
Multiscreen Monitor: The monitor that is connected to
the MULTISCREEN OUT connector on the rear of
the Recorder.
It can display the video input in multiscreen mode
(4, 7, 9, 10, 13,16 screen segments).
It also displays the Recorder’s playback images.
Pressing the SETUP/ESC button for two seconds or
more will automatically select this monitor and dis-
play the Disk Recorder’s Setup menu.
Note: When a Disk Recorder equipped with the
optional WJ-HDB502 Network Board is
accessed from a PC via a network, the Multi-
screen Monitor screen will turn blue and will not
display live camera images. The monitor
screen will display the message "Controlled
(Network)".
Pressing one of the numeric buttons (1 -
16) will display the selected camera images in a
single spot. This function is not available when
CAMERA GENLOCK ON is selected on the
COMMON SETUP menu.
w
q y
u
!0
i
o
e
r
t
SPOT
OUT
OUT
MULUTI SCREEN
ON
OFF
POWER ON
OFF
POWER
Spot Monitor Multiscreen Monitor
Disk Recorder
WJ-HD500B