Pioneer AVIC-D3 - Manual (Page 23)

Before installing this navigation unit
• Remove the holder.
Loosen the screws (3 × 6 mm) to
remove the holder.
Installation with the holder and side bracket
1. Install the holder into the dashboard.
After inserting the holder into the dash-
board, select and bend the tabs appro-
priate to the thickness of the dashboard
material. (Install this navigation unit as
firmly as possible using the top and
bottom tabs. To secure this navigation
unit, bend the tabs 90 degrees.)
2. Install this navigation unit and
fasten the screws.
Be sure to attach the rubber bush to the
long end of double-ended screw.
3. Attach the trim ring.
Trim ring
Dashboard
Screw (3
× 6 mm)
Rubber bush*1
Double-ended
screw
Dashboard
Holder
Holder
Screw (3
× 6 mm)
22
English
Espa
ñ
ol
Deutsch
Fran
ç
ais
Italiano
Nederlands