Pioneer Elite SC-35 - Manual (Page 43)

Basic Setup 04
43
En
Chapter 4:
Basic Setup
Important
• The procedure for setting the receiver operation
mode differs for the remote controls included with
the SC-37 and SC-35. For the SC-37’s remote control,
set the remote control operation selector switch to
RECEIVER. For the SC-35’s remote control, press the
button. When “set the remote control to
the receiver operation mode” is indicated in these
instructions, use the respective procedure described
above.
Changing the OSD display language
(OSD Language)
The language used on the Graphical User Interface
screen can be changed.
• The explanations in these operating instructions are
for when English is selected for the GUI screen.
1 Switch on the receiver and your TV.
Make sure that the TV’s video input is set to this receiver
(for example, if you connected this receiver to the VIDEO
jacks on your TV, make sure that the VIDEO input is now
selected).
2 Set the remote control to the receiver operation
mode, then press HOME MENU.
A Graphical User Interface (GUI) screen appears on your
TV. Use
/// and ENTER to navigate through the
screens and select menu items. Press RETURN to exit
the current menu.
3 Select ‘System Setup’ from the Home Menu.
4 Select ‘OSD Language’ from the System Setup
menu.
5 Select the desired language.
6 Select ‘OK’ to change the language.
The setting is completed and the System Setup menu
reappears automatically.
Automatically conducting optimum
sound tuning (Full Auto MCACC)
The Full Auto MCACC Setup measures the acoustic
characteristics of your listening area, taking into account
ambient noise, speaker connection and speaker size, and
tests for both channel delay and channel level. After you
have set up the microphone provided with your system,
the receiver uses the information from a series of test
tones to optimize the speaker settings and equalization
for your particular room.
SC-37 only: By performing the Full Auto MCACC Setup
procedure, the frequency-phase characteristics of the
connected speakers are also calibrated.
Once the Full Auto MCACC Setup procedure is
completed, the Full Band Phase Control function is
automatically turned on (page 63).
Important
• Make sure the microphone and speakers are not
moved during the Full Auto MCACC Setup.
• Using the Full Auto MCACC Setup will overwrite any
existing settings for the MCACC preset you select.
• Before using the Full Auto MCACC Setup, the
headphones should be disconnected.
CAUTION
• The test tones used in the Full Auto MCACC Setup
are output at high volume.
THX ®
• THX is a trademark of THX Ltd., which may be
registered in some jurisdictions. All rights reserved.
1 Switch on the receiver and your TV.
Make sure that the TV’s video input is set to this receiver.
2 Connect the microphone to the MCACC SETUP MIC
jack on the front panel.
• Push down on the lower portion of the front panel
door to access the MCACC SETUP MIC jack.
RECEIVER
SC-37_35_UXJCB.book 43 ページ ２０１０年３月９日 火曜日 午前９時３２分