Panasonic KX-FLB811 - Manual (Page 36)

3. Fax
34
3.6 Broadcast
transmission
By storing one-touch dial and navigator directory
items (page 31) into the broadcast memory, you
can send the same document to multiple parties
(up to 20). Your programmed items will remain in
the broadcast memory, allowing frequent re-use.
L The broadcast function utilizes stations 1–3.
The one-touch dial function will be canceled.
L Keep the front cover page open for button
locations.
L Make sure that the {FAX} light is ON.
3.6.1 Programming items into
the broadcast memory
1 Press {MENU} repeatedly to display
“
DIRECTORY SET”.
2 Select the desired broadcast key.
For BROADCAST 1-2:
1. Press the desired {BROADCAST} key.
2. Press {V} or {^} repeatedly to select
“ BROADCAST”.
For MANUAL BROADCAST:
1. Press {MANUAL BROAD}.
2. Press {V} or {^} repeatedly to select
“ MANUAL BROAD”.
3 Press {SET}.
4 Program items.
Using stations 1–7:
Press the desired station key.
Using stations 8–14:
Press {LOWER}, then press the desired
station key.
Using navigator directory:
Press {V} or {^} repeatedly to display the
desired item, and press {SET}.
Using the dial keypad (only for MANUAL
BROAD):
Enter the fax number and press {SET}.
L To program other items, repeat this step
(up to 20 items).
L If you program the wrong item, press
{
STOP} to erase the item.
5 Press {SET} after programming all of the
desired items.
L To program another broadcast key,
repeat steps 2 to 5.
6 Press {STOP} to exit.
Note:
L Confirm the stored items by printing a
broadcast programming list (page 89).
3.6.2 Adding a new item into the
broadcast memory
After initial programming, you can add new items
(up to a combined total of 20).
1 Press {DIRECTORY}.
2 Press {V} or {^} repeatedly to display the
desired broadcast memory
(“
”, “” or
“ ”).
3 Press {MENU}.
4 Press {*}.
5 Press {V} or {^} repeatedly to display the
desired item you want to add.
6 Press {SET}.
L To add other items, repeat steps 5 and 6
(up to 20 items).
7 Press {STOP} to exit.
Note:
L When adding new items to the MANUAL
BROADCAST memory, you can only select
stored items.
3.6.3 Erasing a stored item from
the broadcast memory
1 Press {DIRECTORY}.
2 Press {V} or {^} repeatedly to display the
desired broadcast memory
(“
”, “” or
“ ”).
3 Press {MENU}.
4 Press {#}.
5 Press {V} or {^} repeatedly to display the
desired item you want to erase.
L To cancel erasing, press {STOP}.
6 Press {SET}.
7 Press {SET}.
L To erase other items, repeat steps 5 to 7.
FLB811-PFQX2307ZB-en.book Page 34 Thursday, February 16, 2006 3:57 PM