Paradyne BitStorm 4800 Express - Manual (Page 27)

2. Cabling
4821-A2-GN21-10 July 2004 2-5
Console Port
The CONSOLE port normally serves as the primary user interface with the
BitStorm 4800 Express during installation. You can connect a terminal or PC
directly to the CONSOLE port using a DTE cable (see procedure below). You can
also use the CONSOLE port to attach a modem to the BitStorm 4800 Express for
remote dial-in management of the unit using a DCE cable (see
Connecting a
Modem to the Console Port on page 2-6).
Connecting a Terminal or PC to the Console Port
Procedure
To connect a terminal or PC to the CONSOLE port:
1. Configure the terminal or terminal emulation program to use the following
parameters:
— Speed: 9600 bps
— Data bits: 8
— Parity: None
— Flow Control: None
— Stop bits: 1
2. Determine and procure the proper Data Terminal Equipment (DTE) cable type.
The CONSOLE port requires a DB9 plug connector. The other connector
depends on the serial port on your terminal or PC.
3. Connect the DB9 plug connector to the CONSOLE port socket. The
CONSOLE port is ordinarily used only during installation, so do not fasten the
connector.
4. Connect the other end of the cable to the serial port of your terminal or PC.
04-17530
Serial
Port
PORT1 10/100BT
CONSOLE
PORT2 10/100BT
S TA TU S
A LA R M
TE S T
DSL PORTS 1-2 4
25
47
27 29 31 33 35 37 39 41 43 45 26
48
28 30 32 34 36 38 40 42 44 46
1
23
3 5 7 9 11 13 15 17 19 21 2
24
4 6 8 10 12 14 16 18 20 22