Paradyne BitStorm 4800 Express - Manual (Page 13)

1. Installation
4821-A2-GN21-10 July 2004 1-3
Cables Required
Table 1-2 shows all the cables that may be required for your installation.
Table 1-2. Cable Descriptions
Connector Name Connector and Cable For Connecting . . .
DSL PORTS 1–24
DSL Ports 25–48
(if installed)
50-pin RJ21X Telco-type
straight connector and 50-wire
cable. Two cables required for
48-port model. Up to 24 DSL ports per cable to
a POTS splitter.
Port 2
10/100BaseT 8-position modular plug and
8-wire Category 5 or better
unshielded twisted pair (UTP)
cable. The BitStorm 4800 Express to a
network.
Port 1
10/100BaseT 8-position modular plug and
8-wire Category 5 or better
unshielded twisted pair (UTP)
cable. A Network Management System
(NMS) over a Local Area
Network (LAN) employing
10BaseT or 100BaseT.
CONSOLE DB9 plug connector and
shielded cable.
„ The other connector
depends on the serial port on
your terminal or PC, but
normally is a DB9 socket.
„ The other connector
depends on the serial port on
your modem, but normally is
a DB25 plug. A null modem
(crossover) cable is required.
The BitStorm 4800 Express to
one of the following:
„ A terminal or a PC with a
terminal emulation program,
or
„ A modem.