Paradyne Hotwire ATM Line Cards 8385 - Manual (Page 74)

4. Monitoring
4-8 February 2003 8335-A2-GB20-70
DSL Link Performance Summary Screen – Model 8385 B-B-D
Shows performance statistics for the DSL link at the physical layer.
Enter a port name (dsl1–dsl24) to see current statistics.
CPE Vendor ID – The manufacturer of the endpoint.
Down Margin – The margin reported by the endpoint, in dB. The larger the number, the
higher the link’s tolerance to noise.
Down Attenuation – The signal attenuation reported by the endpoint, in dB. Generally,
the larger the number, the longer the loop.
Up Margin – The margin detected by the line card, in dB. The larger the number, the
higher the link’s tolerance to noise.
Up Attenuation – The signal attenuation detected by the line card, in dB. Generally, the
larger the number, the longer the loop.
Operating Speed – The DSL line speed in kbps for the downstream and upstream data
paths.
Attainable Speed – The attainable DSL line speed in kbps for the downstream and
upstream data paths, based on the target margin selected and the Signal to Noise Ratio
calculated at startup.
Current Link Up Time – The amount of time since the link became operational, in days,
hours, minutes, and seconds.
Card Up Time – The amount of time since the line card was last reset, in days, hours,
minutes, and seconds.
Relative Capacity – The operating speed relative to the attainable speed expressed as a
percentage for the downstream and upstream data paths.
Number of Repeaters in Loop – The sum of the number of repeaters in the loop (1– 8).
Table 4-2. Monitoring – Physical Ports (4 of 6)