Paradyne Hotwire ATM Line Cards 8385 - Manual (Page 23)

8335-A2-GB20-70 February 2003 3-1
3
Configuration
Overview
This chapter provides instructions on how to access the system for the first time
and perform initial setup procedures. These procedures may include:
Entering Card Information on page 3-2
Setting Spectrum Management (Models 8355 and 8385) on page 3-4
Configuring the DSL Ports on page 3-8
Configuring the ATM Physical Layer (Models 8335, 8365, and 8385) on
page 3-24
Configuring ATM Parameters on page 3-26
Configuring ATM Cross Connections on page 3-28
Configuring ATM Traffic Profiles on page 3-32
Clearing Cross Connections on page 3-37
Configuring Rate Shaping (Models 8335, 8365, 8385) on page 3-38
Entering Service Node Management Configuration Information (Models 8335
and 8385)
on page 3-42
In cases where there is a substantive difference between the screens for the
different card models, an example for each card model is shown. For most
screens the only difference is the model number and number of ports displayed in
the message area.
Saving and Restoring Configuration Options
If you have a saved configuration options file you would like to download to the
card, or if you would like to save a copy of the current configuration file, use the
NVRAM Configuration Loader screen. See
Uploading and Downloading a
Configuration in Chapter 6, Maintenance Procedures.
If you have altered configuration options in error and would like to ensure that you
are using factory default configuration options, use the Clear NVRAM screen to
restore them. See
Clearing NVRAM in Chapter 6, Maintenance Procedures.