Planar C3i/EX - Manual (Page 39)

Dome C3i Specification | 29
Dome C3i Specification
In locations where 240V outlets are used, connect the Dome C3i display to only a center-
tapped, 240V, single-phase supply (only for Canada and the United States).
Category Characteristic Item Specification
Screen Screen size diagonal 528 mm (20.8 in.)
Resolution 1536 x 2048 pixels (portrait)
2048 x 1536 pixels (landscape)
Pixel pitch 0.207 x 0.207 mm
Pixel arrangement Subpixel vertical stripe
Active area (mm) 423.9 (H) x 318.0 (V)
Grayscale supported 3061 shades of gray – programmable gamma
Refresh rate 60 Hz
Contrast ratio 600:1 (typical)
Brightness 200 fL (typical); 700 cd/m 2 (when new)
Pixel rise/fall time 50 ms
Viewing angle 160° (± 85°) horizontal/vertical
Interface Digital Video In 1 DVI single-channel digital connector
Display control - brightness DDC2B+
Display identification EDID read using DDC2B+
USB hub Universal Serial Bus (USB) Rev. 1.1:
1 uplink B port; 2 downlink A ports
Display status Dual-stack tricolor LEDs on back panel
Input formats Landscape orientation 2048 x 1536 (8-bit per pixel)
Portrait orientation 1536 x 2048 (8-bit per pixel), automatic hardware rotate
by DX2 board
Screen type AMLCD (active-matrix liquid crystal display)
Physical Display size (without stand) 485.9 mm x 381.0 mm x 101.6 mm
(19.1 in. x 15.0 in. x 4.0 in.)
Display weight (without stand) 6.35 kg (<15 lb)
Mounting options Desktop stand with integrated USB (standard);
100-mm VESA mounting (optional)
Power Adapter Ault MW122KA1223F52 (CAUTION: Use only the power
adapter supplied with the display unit.)