Planar C3i/EX - Manual (Page 16)

6 | Dome Display
Set the DIP Switch on the Dome DX2 Board
You need to disable VGA mode and enable EPROM on
the DX2 display controller for Solaris systems.
To disable VGA
Slide switch 1 into the OFF position.
To enable EPROM
Slide switch 2 into the ON position.
To set landscape mode as default display mode
Slide switch 4 into the ON position. (NOTE: For Dome C3i only.)
Tips
• Access to ports. For displays mounted on a desk stand, rotate the
LCD panel from portrait to landscape for access to the ports.
• Threading cables. Thread the DVI cable and power cord through
the back of the stand. Make sure the cable and cord run through
the notches. To reattach the stand cover, align the hooks with the
slots on the stand. Press the cover into place. A click sound signals
a secure connection.
• Multiple displays. Connect the first display of a two-headed
system, or the only display of a one-headed system, to the Video 1
port. Connect all displays to the controller before you turn on the
computer and install the driver.
VIdeo 1 port