To modify the owconfig file – Planar C3i/EX User Manual
Page 25
Installing the Display | 15
To modify the OWconfig file
This section explains the first example from the preceding sample
code, line by line, and tells how to modify those lines to match the
device you are installing.
class="XSCREENCONFIG" name="DOMEdx2pci0Config"
The name provided here must be unique in the OWconfig file. You
can alter it as long as you select a name that is not used for any other
XSCREENCONFIG section.
device="/dev/dx2pci0.0"
This line indicates the installation of a DX2 board to which the system
assigned the instance of zero (0). The second zero (0) indicates that
you are using the first head. To modify this line for the device you are
installing, replace the first zero (0) with the instance the system
assigned to your board. For the second head, replace the second
zero (0) with a one (1).
res="1536x2048e Panel"
This line indicates that the resolution of your flat panel (pre-adjusted
timing name) is "1536x2048e Panel". See the table on
to
select the correct pre-adjusted timing name for your panel type.
monitor="domegray.vda"
This line indicates that you are using a grayscale display and
that the pre-adjusted timing name is located in the display file
domegray.vda.
Display files are located in the /opt/DOMEdx2pci/monitors directory.
Do not modify these files unless Planar Support advises you to do so
.
WARNING – Modifying code
When you modify the line res="1536x2048e Panel", use the
exact name for your display from the “Pre-Adjusted Timing Name”
column in the table on
.
To support a color display, use "domecolr.vda" in place of
"domegray.vda".