Philips LC5241 - Manual (Page 10)

Inserting the batteries in the remote control
1. Press firmly and slide the
battery cover off.
2. Insert the two supplied
batteries (size
AAA1,5V/LR03). Ensure
that the polarities
(+ and –) of the batteries
are aligned correctly.
3. Slide the cover back until
it snaps into place.
Caution!
Do not mix old and new batteries (also never mix alkaline and
manganese batteries).
Using the remote control as PC mouse
The remote control of this projector can be used as the PC
mouse (wireless mouse function) by connecting the Mouse
connector of this projector and the PC. The PC Mouse functions
of the Remote Control function after pushing the Mouse button
on the RC Unit.
Remote control mouse functions
•
The cursor key on the remote control operates the computer
mouse functions.
• If a computer running Windows is connected, the OK button
on the remote control operates as the computer mouse left
click button and the Cancel button as the computer mouse
right click button.
• If a Macintosh computer is connected, the OK and CANCEL
buttons operate in the same way as the computer mouse
click button.
Note: The remote sensors are located on the front and back of
the projector. The controllable range is 50 degrees
horizontally and 30 degrees vertically relative to a line that
is at a right angle to the remote sensor. And the distance
between the point of the remote control and remote
sensor must be shorter than four meters (13 feet).
Auto im age Inp ut Stan dby /On y
OPE N
Status
30˚
30˚
50˚
50˚
6. Set Up
10