Philips PT-F100NTE - Manual (Page 49)

Technical Information
E
NGLISH - 49
Appendix
You can remotely operate the projector from the outside the Remote control range by connecting to the REMOTE
terminal.
J Pin assignments and signal names
J LAMP switching
J Switching input signals
REMOTE terminal
Pin No. Signal name Contents
A GND Ground
B POWER POWER ON
C INPUT SEL3 Select input signal 3
D NC
E INPUT SEL1 Select input signal 1
F INPUT SEL2 Select input signal 2
G
Connect internally
H
I ENABLE Control by external contact
Pin No. Settings
B - A Short Open
Operation On Off
Pin No. Settings
C - A Open Open Short Short Short Open
E - A Open Short Open Open Short Short
F - A Open Open Short Open Open Short
Input signal COMPUTER1 COMPUTER2 COMPONENT VIDEO S-VIDEO NETWORK
NOTE:
• When pin A and pin I are short-circuited, the buttons on the projector’s control panel, POWER and INPUT SELECT
buttons on the Remote control cannot be used. In addition, the RS-232C commands and network functions that
correspond to these functions cannot be used either.
• While pin I is “Open”, do not short-circuit pin A, B, C, E and F. The projector would reject all the signals from the
Remote control.