Philips PT-F100NTE - Manual (Page 17)

Getting Started
Setting up
E
NGLISH - 17
You can use the projector with any of the following 4 projection methods. To set the desired method in the projector,
See “INSTALLATION” on page 37.
You can screw up/down the front leg adjusters to control the angle of the projector for adjusting the throwing angle.
See “Positioning the image” on page 24.
Projection method
J Setting on a desk/floor and
projecting from front J Setting on a desk/floor and
projecting from rear
INSTALLATION: FRONT/DESK INSTALLATION: REAR/DESK
J Mounting in the ceiling and
projecting from front J Mounting in the ceiling and
projecting from rear
INSTALLATION: FRONT/CEILING INSTALLATION: REAR/CEILING
NOTE:
• A translucent screen is required for rear projection.
• When mounting the projector in the ceiling, the optional ceiling mount bracket (ET-PKF100H, ET-PKF100S) is required.
• See “Ceiling mount bracket safeguards” on page 44.
Front leg adjusters and throwing angle
NOTE:
• Heated air comes out of the Air exhaust port. Do not touch the Air exhaust port directly.
• If keystone distortion occurs, see “KEYSTONE” on page 34.