Philips PT-F100NTE - Manual (Page 23)

Basic O
p
eration
Switching the projector on/off
E
NGLISH - 23
1. Switch the MAIN POWER on.
The power indicator lights up in RED.
2. Open the Front panel cover.
This is not necessary in Remote control operation.
3. Press the POWER button.
The power indicator lights up in GREEN after
flashing for a while.
The STARTUP LOGO is displayed on the screen.
See “STARTUP LOGO” on page 36.
1. Open the Front panel cover.
This is not necessary in Remote control operation.
2. Press the POWER button.
The confirmation screen is displayed. It will
disappear and return to the projection after
10 seconds without any operation.
To return to the projection, press any button except
the POWER button.
3. Press the POWER button.
The power indicator lights up in ORANGE while
cooling the lamp, then illuminates RED when is
ready to switch off the MAIN POWER.
4. Switch off the MAIN POWER on the back of the
projector.
Switching on the projector
NOTE:
• Some small rattling or tinkling sound may be heard when starting up, but this is normal and does not affect the
performance of the projector.
• If you disconnected the Mains lead or switched off the MAIN POWER while on projecting mode, the projection will start
with connecting the Mains lead or switching on the MAIN POWER. See “DIRECT POWER ON” on page 37.
Switching off the projector
NOTE:
• Press the POWER twice or for a long duration to switch the power off.
• You can disconnect the Mains lead or switch off the MAIN POWER instead of following this procedure. See “DIRECT
POWER ON” on page 37.
• You can turn off the projector by pressing the POWER button longer than 0.5 seconds.