Recording 05 – Pioneer DVR-330-S User Manual

Page 43

Recording

Before recording, make sure that the audio input for the
DV IN jack is setup (see DV Input on page 70).

Important

• The source signal must be DVC-SD format

• Some camcorders cannot be controlled using this

recorder’s remote.

• If you connect a second recorder using a DV cable,

you cannot control the second unit from this one.

• You can’t control this unit remotely from a

component connected to the

DV IN jack.

• You can’t record date and time information from DV

cassette.

• During DV recording, if a part of the tape is blank, or

has copy-protected material on it, this recorder will
pause recording. Recording will restart automatically
when there is a recordable signal. However, if there is
more than 10 seconds of blank tape, this recorder will
stop recording and the camcorder should stop
(depending on the camcorder).

• For best results when recording from a DV

camcorder to this recorder, we recommend cueing
the camcorder to the place you want to start
recording from and setting the camcorder to play-
pause.

Make sure your digital camcorder is connected to

the front panel DV IN jack.
Also, set the camcorder to VTR mode.

Set up the recorder.

• Use

REC MODE to set the recording quality. See

Setting the picture quality/recording time on page 33
for detailed information.

Load a recordable disc into the recorder.

From the Initial Settings menu, check that the DV

audio input is setup as you require.
See DV Input on page 70 for more on this.

• Check also that the

Audio In settings for External

Audio and Bilingual Recording are as you want
them (see Audio In Settings on page 69).

Press HOME MENU and select ‘DV Record’ from

the menu.

• DV recording only works when the digital camcorder

is in VTR mode with a tape loaded.

Find the place on the camcorder tape that you

want to start recording from.
For best results, pause playback at the point from which
you want to record.

• Depending on your camcorder, you can use this

recorder’s remote to control the camcorder using the

, , ,

and

buttons.

Use the

/ buttons to select ‘Start Rec’ and

press ENTER.

• Recording is automatically paused if the recorder

detects no signal, or a copy-protected signal.
Recording restarts when there is a non-copy-
protected signal.

• You can pause or stop the recording by selecting

Pause Rec or Stop Rec from the on-screen display.
You cannot control the camcorder from this remote
control during recording.

• If you restart recording after stopping the camcorder,

the first few seconds of the camcorder tape will not
be recorded. Use the pause button on your
camcorder instead and recording will start
immediately.

• DVD-RW (VR Mode) only: A chapter marker is inserted

every time there is a break in the timecode on the DV
tape. This happens when the recording is stopped or
paused then restarted, for example.

• While recording, you cannot exit the DV recording

screen using the

HOME MENU or RETURN button.

• See also DV-related messages on page 80 if you

encounter an error while using the

DV IN jack.

RETURN

HOME

MENU

ENTER

PAUSE

STOP

REV SCAN

PLAY

FWD SCAN

STEP/SLOW

REC MODE

Start Rec

Pause Rec

Stop Rec

SP (2h00m)

1h59m

Stop

1.02.22

Control with these
buttons

Rem.

DVD

06 Recording.fm 43 ページ２００５年３月１日　火曜日　午後１１時１９分