Pico Macom SIRD-FTA - Manual (Page 26)

2. Continuously Move
Select . Then select the direction by using VOL+/–.
By pressing VOL+/–, the dish will move. The motor stops after releasing VOL+/–.
3. Step Size
You can set the step size from 1 to 10 for move steps.
4. Move Steps
Select the direction by using VOL+/–.
The dish moves step by step.
Adjust the dish to the best position.
5. Limit Set
Select . Then select direction limit by using VOL+/–. Press OK,
then set the East Limit, West Limit or Disable the limit.
6. Save Position
Save the position of the satellite.
7. Go to Position
Press for the motor to return to the last position of the satellite.
8. Go to Reference
This provides a list of factory settings.
H. FTA Only
FTA Only to search only free-to-air channels.
FTA Only to search all channels.
I. Start Search
a. Select by using CH+/–.
b. Select Sat/TP/Network by using VOL+/–.
Sat: Search satellite channels
TP: Search transponder channels
Network: Network search of the satellite
c. Press OK to view the sub-menu as shown in the figure atop next page.
26
4.3 Installation Settings
MAIN MENU