Pentax Optio S5i - Manual (Page 15)

13
This section describes the procedures for installing the necessary
software for Macintosh. The procedures below are based on Mac OS X
(ver.10.3) unless specified otherwise.
1
Turn on your Macintosh.
2
Insert the CD-ROM (S-SW25) into your Mac’s CD-ROM
drive.
3
Double-click the [CD-ROM (S-SW25)] icon.
4
Double-click the [Install ACDSee] icon.
The PENTAX Software Installer screen will appear.
Double-click the [Master Installer] icon to display [PENTAX
Software Installer] screen.
5
Click your applicable language.
You can choose the languages from the displayed screen.
A selection screen to install your desired software is displayed.
6
Click [Mac OS 8.6].
The software selection screen will
appear.
7
Click [USB Driver].
The USB driver will be installed.
When installation is completed,
reboot your Macintosh.
Installing the Software (for Macintosh)
Installing the USB driver (Mac OS 8.6 only)