Printek 4000se - Manual (Page 56)

P R I N T E R C O N F I G U R A T I O N
48
Cut Adjustment Cut Adjustment
0
Possible Values: Auto, -0.2951” … 0* … +0.2951”, Auto
This item may be used to adjust the position of the cut relative to the top-of-
form for improved cut accuracy. This item is only available when the
optional FormsCutter is installed. Refer to the FormsCutter manual for
more information.
Lines Per Inch Lines/Inch
6
Possible Values: 6*, 8
This item sets the line pitch to 6 or 8 Lines Per Inch (LPI).
Form Length Form Length
66 Lines
Possible Values: 1 … 66* … 227 Lines
This item sets the form length in lines at the current line pitch (LPI). For
example: for an eleven-inch form, enter 66 if you are using six lines per inch
or 88 if you are using eight lines per inch.
Top Margin Top Margin
0 Lines
Possible Values: 0* … 226 Lines
This item sets the top margin in lines. Setting a top margin will reduce the
size of the printable area of the page by the number of lines set. Printing will
not be allowed above the top margin.
Note: In most cases changing where printing begins on a form should
be accomplished with ALIGN PRINT rather than with a top
margin. Adding a top margin may cause some programs to