Printek 4000se User Manual

Page 24

G E T T I N G S T A R T E D

FormsPro 4503se with Form Installed in Front Tractors.

FormsPro 4503se Tri-Trak Model

1. To install forms in the other sets of tractors in the

FormsPro 4503se:

2. Press the FORM SELECT button on the front panel until the

desired form setup and tractor path is selected on the LCD
display (this button's sequence is 0 through 9, and back to 0, and
may be operated while the case is either opened or closed).

3. Then press the LOAD button. This causes the selected tractors to

move into position for loading.

4. To load paper or forms, open the door on each tractor and

position the holes in the paper over the pins in the tractors; then
close the doors.

5. If the tractors are not set at the proper width for the paper you are

loading, simply move the lever beside the right tractor door to the
open position and the tractor will slide sideways.

6. Now close the case, select the form you desire (0 through 9), and

press the LOAD button. This places the form you have selected
into position for printing.