Printek 4000se User Manual

Page 52

P R I N T E R C O N F I G U R A T I O N

Entering Setup

To enter Setup, simply take the printer off line and press the SETUP button.
The SETUP indicator will begin to flash yellow and the display will
temporarily show the following.

Entering

Setup Menus

After the above message has been shown, the display will change to the first
menu available, which is the

FORMS MENU

as shown below. In this case the

display will also show which form is to be set up.

FORMS MENU
Form 0

Using the SETUP Button

At this time you may select a different menu by pressing the SETUP button.
Other menus available are the INTERFACE MENU, the OPTIONS
MENU, and the TEST MENU. This button will also display an option for
exiting Setup. If you do not wish to exit Setup at this time, press either
FUNCTION button. The SETUP button may be pressed at any time to select
a different menu.

Using the FUNCTION and VALUE Buttons

Once the correct menu is selected, pressing either of the FUNCTION buttons
will cause the various items and their current values to be displayed. Note
that the items and their values are right justified and are thus controlled by
the buttons to the right of the display. To scroll through the items available,
use the FUNCTION buttons. To change the value of the displayed item, use
the VALUE buttons to step through the possible choices. Remember to
leave the correct value displayed before selecting a different item or menu,
since “what you see is what you get” when Setup Mode is exited.