Patton electronic CopperLink Ethernet Extenders 2168A - Manual (Page 16)

16
4.0 CONFIGURATION
The CopperLink Models 2168A and 2168A/TB45 have an eight-position
DIP switch for configuring the unit for a wide variety of applications. This
section describes switch locations and explains the different configura-
tions. The Model 2158A does not include dip switches.
4.1 CONFIGURING THE HARDWARE DIP SWITCHES
Using a small flat-tip screwdriver, remove the protective cover located on
the underside of the CopperLink Ethernet Extender (see Figure 8).
Figure 8. Removing protective cover
Figure 9 on page 16 shows the orientation of the DIP switches in the On
and Off positions.
Figure 9. Models 2168A and 2168A/TB45 DIP switch orientation
CopperLink™ Ethernet Extender
Cop per Link
SW
SW