Patton electronic CopperLink Ethernet Extenders 2168A - Manual (Page 13)

13
Connecting the ferrite clamp to the terminal block.
To connect the ferrite clamp to the terminal block:
1. Place the cable inside the ferrite clamp, leaving about 1-2 inches of
cable between the unit and clamp.
2. Wrap the cable tightly around the clamp two times and secure the
wire firmly in the clamp channel.
3. Close the clamp and connect the cable to the line port on the unit
(See Figure 2 on page 9).
Figure 6. Connecting the ferrite clamp for 2168A/TB45 models
Ferrite clamp
CopperLink twisted-pair
RJ-45 interface
Model 2168A/TB45
Note: Be sure to leave 1-2 inches
of cable between the unit
and the ferrite clamp.
CopperLink twisted-pair
terminal block
interface