Patton electronic CopperLink Ethernet Extenders 2168A - Manual (Page 14)

14
3.4 CONNECTING THE 10/100BASE-T ETHERNET INTERFACE
The RJ-45 port labeled Ethernet is the Auto-MDIX10/100Base-T inter-
face. This port is designed to connect directly to a 10/100Base-T net-
work. Figure 7 shows the signal/pin relationships on this interface. You
may connect this port to a hub or PC using a straight through or cross-
over cable that is up to 328 ft long.
Figure 7. CopperLink Ethernet Extender 10/100Base-T RJ-45 Connector Pinout.
1 TX+/RX+ (data output from CopperLink)
2 TX-/RX- (data output from Copperlink)
3 RX+/TX+ (data input to CopperLink)
4 (no connection)
5 (no connection)
6 RX-/TX-(data input to CopperLink)
7 (no connection)
8 (no connection)
1
2
3
4
5
6
7
8