Pelco Dx8000 - Manual (Page 8)

8 C623M-C (3/05)
Additional Warnings and Cautions
It is recommended that the recorder be connected to an uninterruptible power supply (UPS) capable of supplying 2A for 120 VAC power systems
or 1A for 230 VAC power systems.
IMPORTANT: Read and keep all instructions, including the Important Safety Instruction sheet that was supplied with your DVR.
CAUTION: The recorder should be installed in an air conditioned room where the temperature is maintained between 50° and 90° F (10°
and 35°C) with relative humidity not to exceed 80 percent, non condensing.
WARNING: All operating system files, applications, and utilities necessary to operate the DX8000 have been preinstalled on the unit.
Do not install or use any software, including antivirus utilities, on the DX8000 Series DVR other than those that have been installed at the
factory.
WARNING: Do not install any additional hardware on the DX8000 Series DVR other than those devices listed in the documentation
accompanying the unit. Do not remove, replace, or change any existing hardware in the DX8000 Series DVR without first consulting Pelco
technical support or an authorized Pelco service center.
IMPORTANT: When using the networking capabilities of the DX8000, Pelco recommends that each DX8000 Series DVR be connected to a
secure, private network. Do not directly connect your DVR to a public network such as the Internet.