Pelco Dx8000 - Manual (Page 38)

38 C623M-C (3/05)
TCP/IP PORT AND BANDWIDTH THROTTLE SETUP
The DX8000 uses the TCP/IP networking protocol to communicate over LAN and WAN networks. TCP/IP uses logical network ports to organize
data transmissions and to ensure that data packets are delivered to the proper application. For example, e-mail is traditionally delivered through
TCP/IP port 25 and web pages through port 80. The ports assigned to direct video and control information into and out of the DX8000 are listed
below in Table B, “TCP/IP Ports Used by the DX8000,” on page 38.
Table B. TCP/IP Ports Used by the DX8000
Port Number
User
Configurable
Function
9002 Yes Base port for transmission of video, audio, and interface data
9003 Yes Software upgrade
9004 Yes Emergency agent notification
9005 No Information port
13900 No Ping port
IMPORTANT: You should keep port numbers set at their default values unless there is a known conflict with your existing network
infrastructure. Consult your network administrator before changing any port information on the DX8000.