Panasonic PT-D5600U - Manual (Page 26)

26
Using the digital zoom (– D.ZOOM +) function
A portion of the picture on the screen can be zoomed in with “– D.ZOOM +” buttons of the remote control. It is
useful for highlighting a specific object during the presentation.
Press the “– D.ZOOM +” button of the remote control.
The image is zoomed in.
Change the magnification with the “– D.ZOOM +”
button.
The magnification can be adjusted from 1.0 to 3.0 times.
Use buttons to move the magnified
image.
To restore the original image, press the “MENU”
button.
13%
21%
29%
32%
5%
E 18
122
106
76
47
D
C
B
A
P r o d u c t % 2000 1999
T O T A L
A
B
C
D
E
ADJ
110
131
64
42
26
-5
122
106
76
47
18
368 368
-1
110%
81%
119%
112%
69%
100%
B
C
D
E
131
64
42
26
32%
2
• The digital zoomed state cannot be stored in memory.
• If the input signal format is changed while in digital
zoom mode, the projector will exit digital zoom
function.
• The combined magnification of “POSITION” zoom and
digital zoom is 9.99 times maximum.
Note
Automatic adjustment (AUTO SETUP)
Automatic adjustment function adjust the resolution, clock phase and image position automatically when dots-
structured analog RGB signals such as computer signal are supplied. (Automatic adjustment is not available if
moving picture input signals or signals having a dot clock frequency of more than 108 MHz are supplied.) When
DVI signals are input, the image position is adjusted automatically.
It is recommended to supply images with a bright white frame at the outermost periphery containing characters etc.
that are clear in white and black contrast when the system is in automatic adjustment mode. Avoid supplying
images that involve halftones or gradation such as photographs and computer graphics.
• “CLOCK PHASE” may have been shifted even when the adjustment ended normally.
In this case, manually adjust the “CLOCK PHASE”.
• Automatic adjustments cannot be performed when images with blurred edges or dark images are input.
With Composite sync and G-SYNC sync signals and some types of PCs, it may not be possible to
perform these automatic adjustments.
In this case, manually adjust the items of “INPUT RESOLUTION”, “CLOCK PHASE” and “POSITION”.
• Image may be disturbed for about 4 seconds during automatic adjustment, which is not an abnormal
error.
Note
Using the FREEZE function
The image on the screen displayed when you press the FREEZE button on the remote control is displayed as a still
image until you press the FREEZE button again.
Using the SHUTTER function
If the projector is not going to be used for a certain period of time such as while a meeting is on a break or
preparations are being made, the mechanical shutter can be used to hide the images temporarily.
Press the “SHUTTER” button of the remote control or the main unit.
The image is turned off.
Press the “SHUTTER” button again.
The image comes back.