Panasonic PT-D5600U - Manual (Page 23)

23
Projection
Powering up the projector
When using an optional lens, install a projection
lens before powering up the projector. (Refer to
page 25.)
Remove the lens cover beforehand.
Connect the supplied power cable.
(120 V AC, 50 Hz/60 Hz)
Press the “ I ” marked side of the MAIN
POWER switch to turn on the power.
The power indicator lights up red, and the projector is
placed in the standby mode.
Press the “ I ” button. [on the main unit
or the remote control]
The power indicator illuminates in green and soon
the image is projected on the screen.
Making adjustment and
selection
Roughly adjust the focus of the lens.
(Refer to page 25.)
Press the LENS button on the main unit or the
remote control unit to display a focus adjustment
screen. Pressing
buttons to adjust the
image into focus.
Select and set the projection scheme.
(Refer to page 35.)
Select the input signal by pressing the
input selector button to toggle through
RGB1, RGB2, VIDEO, S-VIDEO and DVI.
[on the main unit or the remote control]
Turn the feet, and adjust the tilt of the
main unit in the front and rear or left
and right.
Use the lens left/right adjustment dial to
adjust the direction of the lens. (page 25)
VD SYNC/HD B/P B G/Y R R/P
SE REMOTE 1 REMOTE 2 IN
RGB 1 IN VIDEO IN S-VIDEO IN
IN OUT
Press the LENS button three times to
adjust the lens shift. (Refer to page 25.)
Press the AUTO SETUP button if the
input signal is RGB/DVI signal. (Refer to
page 26.) [on the main unit or the
remote control]
Fit the image size to the screen size.
Press the LENS button twice and adjust the zoom
of the lens on the lens zoom adjustment menu.
Press the LENS button and adjust the
focus of the lens on the lens focus
adjustment menu.
Display the zoom adjustment menu
again and adjust the zoom of the lens to
fit the image size to the screen size.
(Refer to page 25.)
• If the projector is powered up at about 0 ˚C,
a warm-up period of approximately five
minutes may be necessary to start
projection.
The temperature monitor (TEMP) lights
during the warm-up period.
When the warm-up is completed, the
temperature monitor (TEMP) turns off and
the image is projected on the screen.
• If the surrounding temperature is very low
and the warm-up period exceeds five
minutes, the control determines it as an
abnormal condition and turns off the
power automatically. If this happens, raise
the surrounding temperature to 0 °C or
higher and then turn the main power “on”
and turn the power “on” ( | ).
• It is recommended that the projector be
allowed to warm up for at least 30 minutes
before any adjustments are made to the
focus.
Note