Panasonic PT-D5600U - Manual (Page 21)

21
Connection
Setup precautions
• Before connecting any of your video/audio equipment to the projector, carefully read the owners manual
supplied with the equipment once again.
• All cable connections should be made with the entire system devices, including the projector, first turned off.
• Obtain commercial interconnecting cables for devices supplied with no accessory or optional interconnect
cables.
• Video signals containing too much jitter may cause the images on the screen to randomly wobble or shake.
Inserting a time base corrector (TBC) in the projector’s video line will relieve this problem.
• The projector only accepts composite-video, S-video, analog-RGB (with TTL sync. level), and digital signal.
• Some PC models are not compatible with PT-D5600U/PT-D5600UL/PT-DW5000U/PT-DW5000UL projectors.
• The pin assignments on the S-VIDEO IN terminal are
as follows:
• The pin assignments on the DVI-D input terminal
are as follows (interface with DVI-D output
terminal on PC):
• The pin assignments on the RGB2 input terminal are
as follows:
Viewed from mating side
Pin No. Signal
Ground (luminance)
Ground (colour)
Luminance signal
Colour signal
Pin : Not used.
Pins - , and : Ground.
Viewed from mating side
Signal
R/P R
G/G · SYNC/Y
B/P B
HD/SYNC
VD
Pin No.
Viewed from mating side
Pin No . Signal
T. M. D. S data 2-
T. M. D. S data 2+
T. M. D. S data 2
shield
DDC clock
DDC data
T. M. D. S data 1-
T. M. D. S data 1+
T. M. D. S data 1
shield
Signal
+5 V
Ground
Hot plug sense
T. M. D. S data 0-
T. M. D. S data 0+
T. M. D. S data 0
shield
T. M. D. S clock
shield
T. M. D. S clock+
T. M. D. S clock-
Pin No.
• The DVI-D input terminal supports single link only.
• EDID settings should be performed to suit the DVI
equipment being connected. (Page 34)
• The DVI-D input terminal can be used to connect to a
DVI equipment, but note that images may not appear
or the projector may not work properly when
connected to certain DVI equipment.
• This projector supports HDCP.