Panasonic PT-D5600U - Manual (Page 16)

16
Using a wired remote control
When multiple main units are connected in the
system, connect the units with the M3 stereo mini
jack cable available in the market to simultaneously
control the multiple main units with a single remote
control unit through the REMOTE1 IN/OUT
terminal. It is effective to use the wired remote
control in the environment in which an obstacle
stands in the light path or where devices are
susceptible to outside light.
S B/P B G/Y R R/P
REMOTE 1 REMOTE 2
RGB 1 IN VIDEO IN S-VIDEO IN
IN OUT
Connect to the
secondary projector
M3 stereo mini
jack cable
(available in the
market)
Using the remote control unit
• Use two-core shielded cable of
length smaller than 15 m (49' 2"). If
the cable length exceeds 15 m (49'
2"), or if the shielding of the cable is
inadequate, the operation may be
unsatisfactory.
Attention
Installation
Projection Scheme 1
Front projection
Rear projection
Table standing
Projection Scheme 2
Ceiling mount
(Default position)
Installation geometry
After the projector is roughly positioned, picture size
and vertical picture positioning can be finely
adjusted with the powered zoom lens and lens tilt
mechanism.
Side view
With optional ceiling mount
bracket (ET-PKD55)
261
(10 9 /
32
)
H
H
Screen
SH
180
(7 3 / 32 )
L
L
;
;
;;; 421-541
(16
37
/ 64
-21
19
/ 64
)
Top view
314
(12
23
/ 64
)
157 (6
3
/ 16
)
175 (6 57 /
64
)
87.5 (3 29 / 64 )
L
Screen
SW
L : Projection distance
SH : Image height
SW : Image width
H
: Distance from center of lens to bottom edge
of projected image.
• Do not place or use one projector on
top of another projection unit.
• Leave a clearance of at least 50 cm so
that the ventilation opening on the rear
panel will not be blocked.
Attention
Projection schemes
Any of the following four projection schemes can be used
depending on user’s needs or viewing conditions.
Use “OPTION2” menu (chosen from the MAIN
MENU) to choose the appropriate projection
scheme (see page 35).