Premier Mounts Clevis Mount CTM-MS4 User Manual
Page 12
CTM-MS4
Page - 12 -
Installation Manual
4.
To connect the two wall plates, lie them on a flat surface, end to end. Make sure that the holes line up
(Figure 14).
5.
Insert the hex head bolts through the two holes and secure with M8 Hex nuts (Figure 14).
6.
Thread the provided set screw into one end of the support rod and mount. Once the lower rod is mounted,
thread in the remaining mounting rod onto the end of the set screw and twist until tight (Figure 14).
Figure 14
M8 Hex Head
Nut
M8 x 16mm Hex
Head Bolt
Mounting Rod
Set Screw