Lanier LF215 - Manual (Page 153)

T ROUBLESHOOTING 8.10
No. Not
Assigned
The one-touch or speed
dial location you tried to
use has no number
assigned to it. Dial the number manually using
the number keypad or assign the
number. For storing a number, see
“Automatic Dialing” on page 4.15.
[No Paper]
Add Paper The paper tray has run out
of paper. Load paper in the paper tray. See
page 1.11.
Operation
Not Assigned
You are in the Add/Cancel
operation, but there are
no jobs waiting. Check the display to see if there
are any scheduled jobs. The
display should indicate them in
Standby mode, for example, Delay
Fax.
[Paper Jam 0]
Open/Close Door
Paper has jammed in the
feeding area of the paper
tray. Clear the jam. See page 8.3.
[Paper Jam 1]
Open/Close Door
• Paper has jammed in
the paper exit area.
• A paper jam has
occurred in the
manual feeder or the
machine detects
non-feeding from
the manual feeder.
Clear the jam. See page 8.6.
[Paper Jam 2]
Check Inside Paper has jammed in the
fuser area. Clear the jam. See page 8.5.
[Power Failure]
Power has turned off then
on and the machine’s
memory has not been
saved. You need to restart the job you
were trying to do before the power
failure.
[Retry Redial?]
The machine is waiting for
a specified time interval to
redial a previously busy
station. You can press Enter to
immediately redial, or Clear/
Stop to cancel the redial
operation.
[Stop Pressed]
The Clear/Stop button is
pressed during a copy or
fax operation.
Try again.
[Toner Empty]
The toner cartridge has
run out. The machine
stops printing. Replace with a new toner
cartridge. See page 7.8.
[Toner Low]
The toner cartridge is
almost empty. Take out the toner cartridge and
gently shake it. By doing this, you
can temporarily reestablish
printing operations.
Display Meaning Suggested solutions