Lochinvar GAS HEATER FOR COMMERICAL POOL APPLICATIONS - Manual (Page 38)

Commercial Pool Heaters
38
IIN NS ST TA AL LL LA AT TIIO ON N Continued
Figure 40 (A-C) - Terminal Strip Connection
OPERATION
FOR YOUR SAFETY READ BEFORE
OPERATING
ƽ
WARNING: If you do not follow these
instructions exactly, a fire or explosion may
result causing property damage, personal injury
or loss of life.
A. This pool heater does not have a pilot. It is equipped with
an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
B. BEFORE OPERATING, smell around the pool heater area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle to the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone.
• Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to turn the gas control lever. Never use
tools. If the lever will not turn by hand, don’t try to repair
it, call a qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this pool heater if any part has been under
water. Immediately call a qualified service technician to
replace the pool heater. The possible damage to a flooded
pool heater can be extensive and present numerous safety
hazards. Any appliance that has been under water must be
replaced.
Lighting Instructions
1. STOP! Read the safety information.
2. Program the temperature control to the desired settings
(see Operating Temperature Control, page 40).
3. Loosen knurled screw at the bottom of control panel cover
(see Figure 41).
4. Grasp the bottom of the control panel cover and pull out.
5. Locate the ON/OFF switch inside control area. Switch is
located to the left of the pull out control circuitry tray (see
Figure 42).
6. Turn the power switch to the “OFF” position.
7. This pool heater is equipped with an ignition device which
automatically lights the burners. Do not try to light the
burners by hand.
Figure 41 – Control Panel Cover
B.
C.