Lochinvar 000 - 2 - Manual (Page 3)

GENERAL PRODUCT
INFORMATION
Special Instructions
This manual supplies information for the installation, operation
and servicing of the appliance. Read and understand this manual
completely before installing unit.
Installation and service must be performed by a qualified service
installer, service agency, or the gas supplier.
Unpacking
Upon receiving equipment, check for signs of shipping damage.
Pay particular attention to parts accompanying the boiler which
may show signs of being hit or otherwise being mishandled.
Verify total number of pieces shown on packing slip with those
actually received. In case there is damage or a shortage,
immediately notify the carrier.
Codes
The equipment shall be installed in accordance with those
installation regulations in force in the local area where the
installation is to be made. These shall be carefully followed in all
cases. Authorities having jurisdiction shall be consulted before
installations are made. In the absence of such requirements, the
installation shall conform to the latest edition of the National Fuel
Gas Code, ANSI Z223.1 and/or CAN/CGA-B149 Installation
Code. Where required by the authority having jurisdiction, the
installation must conform to American Society of Mechanical
Engineers Safety Code for Controls and Safety Devices for
Automatically Fired Boilers, ASME CSD 1. All boilers conform
to the latest edition of the ASME Boiler and Pressure Vessel
Code, Section IV.
Warranty
Factory warranty (shipped with unit) does not apply to units
installed or operated improperly.
In most cases, improper installation or system design causes
most operating problems.
1. Excessive water hardness causing a lime build up in the
copper tube is not the fault of the equipment and is not
covered under the appliance manufacturer's warranty (see
Water Treatment, page 28 and Water Chemistry, page 37).
2. Excessive pitting and erosion on the inside of the copper
tube may be caused by too much water velocity through
the tubes and is not covered by the appliance
manufacturer's warranty (see System Temperature Rise
Chart on page 26 for flow requirements).
SAFETY INFORMATION
The information contained in this manual is intended for use
by qualified professional installers, service technicians or gas
suppliers. Consult your local expert for proper installation or
service procedures.
IMPORTANT: Read this owner's manual carefully
and completely before trying to install, operate, or
service this unit. Improper use of this unit can
cause serious injury or death from burns, fire,
explosion, electrical shock, and carbon monoxide
poisoning.
ƽ
DANGER: Carbon Monoxide poisoning may
lead to death!
IMPORTANT: Consult and follow local building and
fire regulations and other safety codes that apply
to this installation. Consult your local gas utility
company to authorize and inspect all gas and flue
connections.
ƽ
WARNING: Should overheating occur or the
gas supply fail to shut off, do not turn off or
disconnect the electrical supply to the pump.
Instead, shut off the gas supply at a location
external to the unit.
ƽ
WARNING: To minimize the possibility of
serious personal injury, fire or damage to your unit,
never violate the following safety rules.
1. This unit is only for use with the type of gas indicated on the
rating plate.
2. If you smell gas
• shut off gas supply
• do not try to light any appliance
• do not touch any electrical switch; do not use any
phone in your building
• immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions
• if you cannot reach your gas supplier, call the fire
department
Installation and
Service Manual
3