Lantronix XPort AR - Manual (Page 35)

6: Line and Tunnel Settings
XPort AR User Guide 35
3. Click Submit.
Line Command Mode
To configure the Command Mode, perform the following steps.
1. Click Line > Line 1 > Command Mode. Figure 6-3 shows the page that displays.
Figure 6-3 Line 1 Command Mode Web Page
Flow Control Select the flow control from the drop-down menu. The default is None.
Xon Char Specify the character to use to start the flow of data when Flow Control is set
to Software. Prefix a decimal character with \ or a hexadecimal character with
0x, or provide a single printable character. The default Xon char is 0x11.
Xoff Char Specify the character to use to stop the flow of data when Flow Control is set
to Software. Prefix a decimal character with \ or a hexadecimal character with
0x, or provide a single printable character. The default Xoff char is 0x13.
Threshold The driver will also forward received characters after Threshold bytes have
been received.
Table 6-1 Line 1 Configuration Fields (continued)
Field Description