Lincoln Electric IM613-B - Manual (Page 33)

C-3 ACCESSORIES C-3
WIRE SPINDLE ADAPTERS
K435 - Permits 14 lb. (6 kg) Innershield coils to be
mounted on 2" (51 mm) O.D. spindles.
K363P - Adapts Lincoln Readi-Reel coils of electrode
30 lb. (14 kg) and 22 lb. (10 kg) to a 2" (51 mm) spin-
dle. Durable molded plastic one piece construction.
Designed for easy loading; adapter remains on spin-
dle for quick changeover.
GUN AND CABLE ASSEMBLIES
A number of Fast-MateTM air cooled and water
cooled gun and cable assemblies as well as fume
extraction models are available for use with the Power
Feed 11. See the appropriate Magnum literature for
detailed information.
K1536-1 WATER FLOW SENSOR KIT
This kit is intended to be used as a means of stopping
wire feeding in the event that the water cooler (for a
water cooled gun) is not turned on. Water cooled guns
can be damaged very quickly if they are used even
momentarily without water flowing.
The K1536-1 has two control leads coming from the
unit that become electrically common when water is
flowing. The .25 inch tab terminals of leads 570 and
572, inside the feed head case, are disconnected from
each other. Then the flow sensor control wires are
connected to leads 570 and 572. Refer to the instruc-
tions that come with flow sensor kit for detailed instal-
lation instructions.
K659-1 GAS GUARD REGULATOR
Adjustable flow regulator with removable adjuster key
for CO2 and Argon blend gases. Mounts onto feeder
inlet, and reduces gas waste and arc start “blow” by
reducing surge caused by excess pressure in supply
hose.
Install the 5/8-18 male outlet of the regulator to the
5/8-18 female gas inlet on the back panel of the wire
drive. Secure fitting with flow adjuster key at top.
Attach gas supply to 5/8-18 female inlet of regulator
per instructions in the INSTALLATION section.
K1649-1 MOUNTING BRACKET-
HORIZONTAL
The K1649-1 provides a bracket for mounting the
Power Feed 11 horizontally on top of the Power
Source. Installation instructions are included with the
bracket.
POWER FEED 11