"W" leads from the three terminals on the
plastic insulator bracket of the rectifier
bridge. Label the leads for reassembly.
Pull the leads out through the power mod-
ule top bracket.

14. Using the 1/2" wrench, remove the flat

strap to the negative output terminal. Pull
the strap through the power module top
bracket.

15. With the 7/16" socket wrench, remove the

four nuts, lock washers, flat washers, and
carriage bolts that hold the power module
bottom bracket to the machine base.

The power module/output rectifier bridge
assembly can now be removed and set to the
side.

REPLACEMENT PROCEDURE

1. Place the assembly back into the machine.

2. Install the four carriage bolts, flat washers,

lock washers, and nuts that hold the bottom
bracket to the machine base.

3. Pull the flat negative output strap through

the top bracket and attach it.

4. Feed the stator "W" leads through the top

bracket and attach them to the terminals on
the glastic insulator bracket.

5. Pass choke lead W11 through the toroid

and connect it to the shunt.

6. Connect plug assemblies P/J50 and P/J51

to the power module PC board (both
sides).

7. Connect the power module capacitor

leads. Torque the capacitor nuts to 50-60
inch-pounds.

8. Replace any cable ties cut during removal.

9. Install the output panel.

10. Connect the ground wire to the output

panel assembly, if removed.

11. Attach the front left and right side panels

and the front control panel.