Lowrance electronic 540c Baja - Manual (Page 86)

78
For connectors and wiring information for another device, see page 18.
For assistance in configuring the unit to communicate with another
device, consult the factory. Customer service phone numbers are in the
back of this manual.
Configure NMEA
You can configure the unit to use specific NMEA sentences.
1. Press
MENU
|
MENU
| ↓ to
S
YSTEM
S
ETUP
|
ENT
.
2. Press ↓ to
C
OMMUNICATIONS
P
ORT
|
ENT
| ↓ to
C
ONFIGURE
NMEA
|
ENT
.
3. A menu appears showing the prefixes of the available NMEA sen-
tences. A check mark next to a prefix means the prefix is in use. Use
↑
↓, → ← to select a prefix, then press
ENT
to turn off the prefix. (Press
ENT
again to check the box and turn on a prefix.)
4. When the desired prefixes are checked or unchecked, press
EXIT
re-
peatedly to return to the previous page.
NOTE:
Placing a check in the checkbox next to Radar at the bottom of the
Communications Port menu will set the Baud Rate to the default
Radar Baud Rate setting.
Coordinate System Selection
The Coordinate System Menu lets you select the coordinate system to
use when displaying and entering position coordinates.
Menus for changing coordinate system used to display positions.
To get to Coordinate System Selection:
1. Press
MENU
|
MENU
| ↓ to
GPS S
ETUP
|
ENT
.
2. Press ↓ to
C
OORDINATE
S
YSTEM
|
ENT
.
This unit can show a position in degrees (36.14952°); degrees, minutes
and thousandths of a minute (36° 28.700'); or degrees, minutes, seconds
and tenths of a second (36° 28' 40.9"). It can also show position in: UTM