Lennox Hearth WHITFIELD 30 FS-2 - Manual (Page 45)

45
SIMPLE OPERATING
INSTRUCTIONS
Pellet Stove Models:
ADVANTAGE OPTIMA AND PROFILE SERIES
TRADITIONS T300P
-2
SERIES
3. Priming the Auger a]
Fill hopper with pellets
Note: use quality grade pellet fuel. b]
Push the on/off button to
turn on the auger motor. c]
After 2 minutes push the
on/off button. Wait 5 minutes and push the on/off button to start. d]
When pellets begin to
drop from feed tube into UltraGrate
TM
, push the on/off
button
to stop the auger.
2. Preparation a]
Check hopper and
remove any materials from hopper and auger. b]
Preset damper
c]
Visually check venting and
termination for leakage. d]
Check UltraGrate
TM
for
proper fit (ensure grate is set securely in the base). f]
Check door gasket and
door latch to ensure tight seal. g] Check ash pan and door for proper seal. Confirm ash slides are closed securely (Profile and T300P models only). h]
Connect power cord to
grounded power supply outlet.
4.
Stove is now ready
for start-up.
5. To Start Your
Stove
a]
Push the on/off button
Note: Room air blower and exhaust blower will run at start up settings. 7.
Set stove to desired heat
setting (heat select button).
YES
9. To Turn Off Pellet Stove (Manual Operation Only) a]
Push on/off button, stove enters
shut down mode. b]
Pellets stop feeding and the fire
dies down. Approx. one min. later the room air blower and exhaust blower change to cool down setting. Approx. 15 minutes after shut down cycle begins, stove shuts off.
NO
7a.
Follow the trouble-
shooting section of the Homeowner's "Installation and Operation" Manual.
Does the Stove Light?
8.
After approx. 5 minutes adjust
damper if necessary to obtain a bright vibrant flame. Notes: If the damper is too far closed, the flame will be lazy/sooty and the fuel will pile up in the UltraGrate
TM
.
too much combustion air.
10.
Thank you for purchasing a Whitfield or Traditions by
Lennox Pellet Stove.
END
1. Start
Does the Stove Light?
NO
6.
Flame should appear in
stove within approx. 8 minutes.
Contact your Lennox Hearth Products Dealer for further assistance.
Refer to "Installation and Operation" manual for further instructions in adjusting damper using thermostat vs. manual modes.
PLACE DEALER LABEL HERE
If the damper is too far open, the flame might be extinguished due to
60020191 Rev.
C
e] Check door switch for alignment and contact. Note: Profile 30(-2) models only. Note: Damper is preset at factory for all models except Optima 3 INS and Profile 30 INS-2 (for these models set damper at 1/2 open). For model T300P ensure that damper has not moved from it's factory setting of 3 notches out.
SIMPLE OPERATING INSTRUCTIONS