Lennox Hearth WHITFIELD 30 FS-2 - Manual (Page 28)

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
28
Figure 55 - Opening Side Panels, Profi le ® 20 FS-2
Remove side panel
retaining screw.
Motor Lubrication
The blowers are permanently lubricated by the manufacturer. Do not apply
oil to any part of the blower, doing so may cause damage.
Rear Stove Compartment (All Models)
The rear stove compartment should be cleaned periodically (a minimum
of once a year). DISCONNECT ELECTRICAL CORD PRIOR TO CLEANING
STOVE. Any household dust, pet hair or sawdust should be vacuumed
or wiped out of the rear compartment of the stove, room air blower, and
combustion blower (paying special attention to vacuuming out the intakes
of both blowers). The electrical components should be wiped clean.
Small Area Paint Touch-up
The stove body is painted with a quality high-temperature stove paint.
Use only model TSPK-B Stove Paint, Catalog # 70K99. Do not touch-up
your stove with any other paint.
Using one small piece of 320 grit sand paper and lightly sand the blemish so
that the edges are “feathered” or smooth to the touch between the painted
and bare surfaces. Do not let the sand paper gum up with paint, as this
will cause scratches on the metal surface. If there are any scratches, use
600 grit sandpaper instead. Mask off surfaces you do not want painted.
Paint lightly over the bare surface fi rst as this will act as an undercoat.
Then paint over a larger area in smooth even strokes to blend.