Lennox Hearth WHITFIELD 30 FS-2 - Manual (Page 30)

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
30
Cat. No. H0368 Model Profi le 30 FS-2 Pellet Stove
Flue Size 3” (76 mm) Rear
Width, Overall 25-7/8” (657 mm)
Depth, Overall 24-7/8” (632 mm)
Depth, Overall w / 3” tee 30-3/4” (781 mm)
Height 31-3/8” (797 mm)
Floor to Rear
Flue Center
16-7/8” (429 mm)
Facing Back of Unit,
outside edge on right
to center of rear
fl ue outlet
5-1/8” (129 mm)
Floor to Rear
Outside Air Inlet
10” (254 mm)
Facing Back of Unit
outside edge on left
to center of air inlet
13” (330 mm)
Floor Protection Front and Side: 6” (152 mm)
Requirements Back: 1” (25 mm)
Standard Features Fastfi re™ Self Igniter
Wall Thermostat
(wire included)
Hopper Capacity 70 bs.
Burn time 16 - 41 hours
Fuse, Control Board 5 Amp, 250 volt, 3AG
Fuse, Igniter 6 Amp, 125 volt
Heat Input (Max.) 14,000 - 38,000 BTU / hr
Overall Effi ciency 81%
Emissions 1.9 gr / hr (varies
w / size and type of fuel)
EPA exempt
Ship Weight 270 lbs.
Room Air Blower 150 CFM; .8 Amps,
2175 rpm
Exhaust Blower 95 CFM: 1.0 Amps,
3000 rpm
Auger Motor 1.1 RPM; .4 Amps
Options Nickel or Gold Trim Kits
4” Quick Disconnect
Log Set
BACK VIEW
SIDE VIEW
Note: Dimensions shown are approximations only (+/- 1/4”)
Non-combustible fl oor protection must be used when installed on carpet
(see Floor Protection, Page 5).
Fuel delivery and burn times will vary depending on size and type of fuel
used. Estimated heat input based on fuel value of 8400 BTU per lb.
Fuses are rated as fast blow.
10"
16-7/8"
31-3/8"
25-7/8"
8-7/8”
5-1/8”
13”
30-3/4"
24-7/8"
SPECIFICATIONS - PROFILE ® 30 FS-2