Nonvolatilemethod 1 – using the show-devs command – LSI 7202CP User Manual
Page 34
4-2
Solaris Software Requirements
Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.
4.2.1 nonvolatileMethod 1 – Using the
show-devs
Command
Step 1.
Access the
ok
prompt.
Type the
show-devs
command:
Step 2.
The system displays output similar to this:
ok show-devs
/SUNW,UltraSPARC-III@0,0
/virtual-memory
/memory@m0,0
/aliases
/options
/openprom
/chosen
/packages
/upa@8,480000/SUNW,ffb@0,0
...
/pci@8,700000/IntraServer,fc@2
/pci@8,700000/IntraServer,fc@1,1
/pci@8,700000/IntraServer,fc@1
...
/pci@8,700000/IntraServer,fc@2/disk
/pci@8,700000/IntraServer,fc@2/tape
/pci@8,700000/IntraServer,fc@1,1/disk
/pci@8,700000/IntraServer,fc@1,1/tape
/pci@8,700000/IntraServer,fc@1/disk
/pci@8,700000/IntraServer,fc@1/tape
/pci@8,700000/scsi@6,1/tape
/pci@8,700000/scsi@6,1/disk
ok
•
/pci@8,700000/IntraServer,fc@1
identifies the first Fibre Channel interface on an LSI Logic LSIFC929-
based adapter.
•
/pci@8,700000/IntraServer,fc@1,1
identifies the second Fibre Channel interface on an LSI Logic
LSIFC929-based adapter
Note:
The above are examples. The output of
show-devs
may
vary depending on your system and configuration. Use the
corresponding entries on your system, not the ones given
here.